Jon's Cobra

This car came in for some 304 stainless upper and lower radiator hoses. We used silicone couplers, Mikalor clamps, Vibrant radiator filler neck/billet cap, and Stainless Bros extruded bends on this project. 
After it was done we decided with such a long run on top and 3 couplers it needed a support. Supports like this need to be carefully thought out so they don’t cause other problems like binding and cracking. We decided the best decision was to use one of our saddle mount turbo support kits. This provides support for the tube with the ability to easily adjust tension/pre load, eliminating vibration but still allowing movement as the engine torques over.

Leave a comment

This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.